Fox Rx+ Bite Alarm

Weatherproof sealed caseDigital circuitryDTec Plus Sensing System (DTSS)Drop back differentialLow battery drainCNC machined TruRun roller wheelTwin multicolour LEDs (Red, Green, Blue, Orange, Purple & White)On / Off toggle switch with 2 operational modes (day and night mode)When in night mode both LEDs will subtly glow in your chosen colourHigh quality cone speakerRigid 3/8” stainless steel threadRodfriendly rubber inlaysIndexed ergonomic control for volume (8 different levels of volume with lowest setting being completely silent)Indexed ergonomic control for tone (8 different tone settings: turn dial clockwise to raise pitch and anticlockwise to lower pitch)Indexed ergonomic control for Intelligent Sensitivity featuring SeeSaw elimination (8 different sensitivity settings – see below Sensitivity table for comparison to NTXR)Range test function allows user to check RX+ Receiver is picking up RX+ head at any given rangeLow battery warning (LED colour changes to cyan indicating it is time to replace batteries)Power Out Socket (2.5mm) for use with illuminated SwingersSupplied with two compression washer options: rigid and soft with an additional spare soft washer per unitRequires 2 x AA batteriesRX+ Receiver, 2rod, 3rod and 4rod presentation sets available separately Improved features compared to NTXRDeeper ears with no increase in the height of the alarmTwin multicolour LEDs, one per ear and at the very top of the earExternal control of the multicolour LEDs with Colour Sync function – simply change LED colour via button on the battery coverManually selectable day and night modesExternal control of the VariBright adjustable LED brightness to suit the conditions you are fishing in (choice of 3 LED brightness settings in day mode and 3 different brightness settings in night mode) simply adjust via button on battery coverLarger clearance around the roller wheel and improved drainage vastly reduces chances of roller wheel freezing up in extreme cold conditionsStronger range performance with RX+ ReceiverImproved sensitivity range (see below)Sensitivity ControlIn all sensitivity settings (except maximum), the line must travel the specified distance in the same direction and within 2 seconds in order to trigger the unit. Any movement in the opposite direction will reset the distance counter to zero. This can substantially reduce, or eliminate false triggering caused by wind and water movement.                                                                             Line Movement RX+                       Line Movement NTXRSetting 1 (Min)                      90mm                                                   74mmSetting 2                              73mm                                                   56mmSetting 3                              56mm                                                   48mmSetting 4                              34mm                                                   40mmSetting 5                              17mm                                                   32mmSetting 6                              11mm                                                   24mmSetting 7                              5.6mm                                                  16mmSetting 8 (Max)                     2.8mm                                                  8mmClick here for instruction manual video playlist